Owyhee Dam


Owyhee Dam is a concrete, thick-arch structure which was designed to carry about three-fourths of the water load by arch action and the remainder by gravity action. The dam rises 417 feet above foundation in the river section, and 530 feet above the low point of the excavated fault zone. At the time of its construction, Owyhee ranked as the world's highest dam. The arch section is 623 feet long, and a gravity tangent extends 210 feet to the right abutment. The total capacity of Lake Owyhee is 1,120,000 acre-feet (active 715,000 acre-feet).

Owyhee Dam became a proving ground for theories being developed to assist with the design and construction of Hoover Dam, whose unprecedented size - it would tower more than 300 feet higher than Owyhee - required totally new construction methods. The trial load method of design, developed first for Pathfinder and Buffalo Bill Dams, was refined in the design of Owyhee Dam and, later, Hoover Dam. Cooling methods, necessary to remove excess heat of cement hydration from mass concrete and bring a dam to stable temperatures, were carefully studied. A 28-foot-square section extending through the dam was cooled artificially by circulating river water through 1-inch pipes spaced at 4-foot intervals.

Water for irrigation is diverted through a horseshoe-type tunnel 16 feet 7 inches in diameter and 3.5 miles long. This tunnel heads in the reservoir 80 feet below normal maximum water surface.

The needle valves in the outlet works were replaced by the jet flow gates in 1991 as a part of an operation and maintenance modifications program.


Consists of massive rhyolite and associated pitchstone agglomerate and massive pitchstone. Foundation rock was considered slightly weathered to fresh, moderately hard, and intensely fractured to very intensely fractured. Of note, an 8- to 32-foot-wide zone of highly fractured rock was encountered during construction and was "extensively" treated. This zone strikes normal to the dam axis and is not related to faulting.

RegionFacilities in Pacific Northwest | Pacific Northwest Home Page
Dam TypeConcrete Thick Arch
ReservoirLake Owyhee
WatercourseOwyhee River
Original Construction1928-1932
Modified Construction
National ID NumberOR00582
Hydrologic Unit Code

Structural Height417.0 ft
Hydraulic Height (Normal Operating Depth at Dam)325.0 ft
Top Parapet (Elevation)
Spillway Crest Elevation2658.0 ft
Crest Elevation2675.0 ft
Crest Length833.00 ft
Crest Width30.0 ft
Base Width265.0 ft
Volume of Dam Construction Materials537,500 cu yd
Streambed at Dam Axis
Top of Exclusive Flood Control Pool (Elevation)
Top of Joint Use Pool (Elevation)
Top of Active Conservation Pool (Elevation)2670.0 ft
Top of Inactive Conservation Pool (Elevation)
Top of Dead Storage Pool (Elevation)

Hydraulics & Hydrology
Total Water Storage at Elevation715,000 ac-ft
Maximum Water Surface Elevation
Normal Water Surface Elevation2670.0 ft
Spillway TypeMorning Glory controlled by a 60 ft x 12 ft ring gate
Auxiliary SpillwayNo
Spillway Capacity at Elevation30,000 cfs at 2670.0 ft
Auxiliary Spillway Capacity at Elevation
Uncontrolled Spillway Capacity at Elevation
Outlet Works Capacity at Elevation2,200 cfs at 2670.0 ft
Diversion Capacity at Elevation
Drainage Area10,900.0 sq mi
Hydrometeorological Report (HMR)HMR 57

Contact Information
TitleArea Office Manager
OrganizationSnake River Area Office
Address230 Collins Road
CityBoise, ID 83702-4520
Phone (Fax)208 383-2275
Phone (Office)208 383-2248
OrganizationOwyhee Irrigation District
Address17 South First Street
CityNyssa, OR 97913-3894
Phone (Office)541 372-3540

Last updated: May 31, 2012